Ok I see what u want now my bad ok in trigger editor u have to delete starting units and then change it to player set property and set the food starting other wise it says u louse all the time ok now to the point u say if player is equal to playing create what ever then if not equal to do nothing you might one might have to do this more than once for more than one unit
>One open word editor
>Two open trigger editor
>Three delete starting units for all players
>three.five create in melee installation in actions set player property for player1 food cap to 6 or what every u want
>Four create a new trigger
>Five change Events to map installation
>Six create if/ then/ else
>Seven if change to player number equal to playing
> Eight then change action to create what every u want in the region, which may be put anywhere
> Nine then change second action to do nothing
>Ten should look like this map installation if player 1(red) is equal to playing then do unit create 1 penguin for player 1(red) at center of region001 facing 180 degreases else do nothing
Actually I was just playing with having some kind of mention of the food forum and recipes on the main page to test and see if it would engage some of those people to post something. It is just weird to get so much traffic and no engagement
The bots will show up as users online in the forum software but they do not show up in my stats tracking. I am sure there are bots in the stats but the way alot of the bots treat the site do not show up on the stats
Anyway I need to get some of those sensors and two air pressure sensors installed before an after the filters, which I need to figure out how to calculate the necessary pressure for and I have yet to find anything that tells me how to actually do that, just the cfm ratings
And then I have to set up an arduino board to read those sensors, which I also don't know very much about but I have a whole bunch of crash course things for that
Another issue I'm learning is that a lot of the air quality sensors don't work at very high ambient temperatures. I'm planning on heating this enclosure to like 60C or so, and that's the upper limit of their functionality
Although I don't know if I need to actually actively heat it or just let the plate and hotend bring the ambient temp to whatever it will, but even then I need to figure out an exfiltration for hot air. I think I kind of know what to do but it's still fucking confusing
I don't think I'm dealing with quite the same pressures though, at the very least its a significantly smaller system. For the time being I'm just going to put together a quick scrubby box though and hope it works good enough to not make my house toxic