In GUI?
Set X = X of (Position of (Triggering unit))
Repeat for Y.
Remove the point leak...
Use JASS:
Set Unit = (Triggering unit) (or whatever unit you need)
Custom script: set udg_X = GetUnitX(udg_Unit)
Custom script: set udg_Y = GetUnitY(udg_Unit)
Where X and Y are two global variables of type "real".
Also for w/e reason, if you change a units location it 'forgets' its current orders. If instead you Set its X Coordiante and Y COordinate it keeps its orders.
And then I have to set up an arduino board to read those sensors, which I also don't know very much about but I have a whole bunch of crash course things for that
Another issue I'm learning is that a lot of the air quality sensors don't work at very high ambient temperatures. I'm planning on heating this enclosure to like 60C or so, and that's the upper limit of their functionality
Although I don't know if I need to actually actively heat it or just let the plate and hotend bring the ambient temp to whatever it will, but even then I need to figure out an exfiltration for hot air. I think I kind of know what to do but it's still fucking confusing
I don't think I'm dealing with quite the same pressures though, at the very least its a significantly smaller system. For the time being I'm just going to put together a quick scrubby box though and hope it works good enough to not make my house toxic
I do know this - xenforo dropped the ball by not keeping the vbulletin reputation comments as a feature. The loss of the Reputation comments data when we switched to Xenforo really was the death knell for the site when it came to all the users that left. I know I missed it so much and I got way less interested in the site when that feature was gone and I run the site.