Strange results when using a dialog to move units

[Kinoss]

I've made a dialog that asks the triggering player where to move a large group of recently spawned units in a region. However when I test this trigger in game it doesn't do anything. By accident when I was changing some settings for the trigger I forgot to set the correct region and was therefore set to "Playable area". When I tested this in game All the heroes started moving to the picked spot but no normal units. Here are some visuals for my triggers:

Trigger 1

Trigger 2

Trigger 3



EDIT: Oh, and everything about the dialog seems to work fine. It's just that the units won't move at all.

 

[Regalth]

Interesting. I can only assume that the game didn't notice your spawned units in time to respond to the command. But what are the visuals for? Those triggers don't mention "Playable Map Area" anywhere in them. I'm kind of confused, just what are you asking here?

 

[XXXconanXXX]

Make a variable of type "Unit Group", then in your first trigger, add the last action that reads "Add (Last Created unit) to Your Unit Group variable"". Then, in your move trigger, pick every unit in your unit group variable and move them like so.

Also, make sure the gate isn't opened, because when it is, it's considered dead and the units will not do anything.

 

[Kinoss]

Stranger and stranger...

I tried what you said Conan, but no results. However I did notice some of the units were trying to move but are trapped by the other units. So I thought that maybe there is a limit to how many units can be selected. I scaled down from 120 units being created to 20 units. Now when I run the game and select the "Main Gate" button 12 of the units move to the gate and start attacking it, but the rest don't even care. Now 12 is the max number of units that a player can select but I know that the computer can select all of them... what's up?

 

[XXXconanXXX]

When units get trapped, they stop, period. Try making a few regions like maybe 4 that are right next to eachother, but not overlapping. NOW spawn them in the regions, and add them to the Unit Group.

 

[Kinoss]

Alright, I figured out the problem. I used the "Pick Every Unit in Unit Group and Do Action" instead of "Issue order targeting a ..." command. I guess the Issue order command can only select the same number of units a player can? At any rate It's fixed now. Conan, I dont think that is causing the previous problem because the region they spawned in was large enough to cover all the units to be selected, but on a side not I'm not sure I understood what you said and my response could be rediculous.