Need Spell Ideeas

bLu3_eYeS

New Member
Reaction score
31
Hi guys.Im working at a map: Ashenvale Hero Defense

I currently need Spell Ideeas:
Zeus:
Need 4spell ideeas.
Wind god [level 100 reward hero]
Need 3spell ideeas.He currently has a chance to knockback enemy unit
Nightmare
Need 4 spell ideeas.
Tinker
Need 4 spell ideeas.
1 Completley new hero.Give main attrib , skills , name etc.
 

sidove

Member
Reaction score
22
Nightmare:

Strike Of Shadows
Nightmare strikes the target making him unable to be controlled and running around in terror, any friendly unit that comes in X range of the target will get X decreased armor.

Shadows Reveler
Nightmare casts a curse on the target making, the target take damage over time, if a unit dies in X range of the target the target will create a cloud of shadows on the dieing unit making every unit that goes trough the cloud get the same course as the main target, but the damage over time will decrease for every unit that goes onto the cloud.

Life Stealer
Nightmare drains the life of the unit healing him for X amount and damaging the target for the same.

Embrace of Shadows [Ulti]
Nightmare curses the target making him take the exact damage as Nightmare will for the next 30 seconds. If the target dies he will explode and cast out a nova dealing X damage in a AOE.
 

Necrach

You can change this now in User CP.
Reaction score
62
Wind god

Hurricane prey - Continual. Marks an enemy unit, increasing movement speed and attack speed of any friendly (melee?) unit attacking it. You might use a Frost Shield with negative slow values, if it doesn't work I suppose triggers is the way.

Evasion aura - Passive. Grants Evasion to the Wind God and nearby enemy units.

Divine cloud - Ultimate. Passive with cooldown. When cooldowned, a shimmering cloud surrounds the Wind God and works as a Spell Shield (temporarily blocks a spell for every 2 minutes.) Every time the Spell Shield is used there is an Air Elemental summoned to fight for the Wind God, with a duration as long as the cooldown for the Divine Cloud skill. The Air Elemental is fast, not very resilent but deals ok damage, and can cast Tornado as well as Regenerative Breeze (a weaker versionh of Tranquility.)

EDIT: I posted this and realised this would not be the ideal Hero Defense skill set. My bad. I am sure you can adjust these skills so that they suit battles against a lot of weaker units, if thats the point.
 

AKDevil

New Member
Reaction score
1
Zeus

Wrath of Zues
Lighning strikes the target, killing (or damaging it intensly), causing it to explode, and making nearby enemies flee in terror

Lightning Wave
Zues creates a wave of lighting (strikes?) that travels out from him in all directions, dealing less damage as it travels farther, but make him vulnerable while casting/chaneling it.

umm, that kinda all i got, hope its good
 

Ayanami

칼리
Reaction score
288
Hero Name: Nalmeena, Shadow Assailant
Attribute: Agility

Shadow Mark
Marks an enemy with Nalmeena's shadow. While under the effect of her shadow, the marked unit will revealed when there are no nearby friendly units. Only when the enemy unit is revealed, the marked buff will show. When the marked unit is isolated, Nalmeena can teleport to the shadow, fading in with a delay duration.

Fear
Inflicts fear in an enemy unit. When Nalmeena is in range of the feared unit, the feared unit receives damage and mini-stun every 0.5 seconds. The closer Nalmeena is to the feared unit, the more damage and longer duration mini-stun. Maximum of 0.3 seconds stun per 0.5 seconds. When the feared unit is isolated from friendly units, it has a armor penalty and movement speed penalty.

Abyssal Pierce
Nalmeena is able to easily shatter enemy armor when they are isolated. Every attack, bonus pure damage is dealt to the target as long as there are no friendly units nearby. The bonus damage is greater if the nearest friendly unit is further away. Maximum bonus damage of 100.

Isolation Field
Nalmeena harnesses the essence of darkness and isolates enemies in different dimensions. All enemies within the area have decreased sight range and are in a state of maximum isolation. Enemies cannot escape the Isolation Field. For every unit killed in the Isolation Field, it applies an armor penalty on all enemies within the field until the Isolation Field ends.

This hero would be more of an assassin type hero where you pick off isolated enemies one by one.
 

Necrach

You can change this now in User CP.
Reaction score
62
Man, just got a great idea for your tinker (at least I think so myself :p) The first two skills are nothing extraordinary, but then I got this idea of the Tinker being able to construct combat buildings, see below :)

Robo-Goblin As the original Tinker ultimate, but here it is a normal 3-level hero skill. Strength and armor bonus increases with levels.
Level 1 - +1 Strength.
Level 2 - +4 Strength, +1 armor.
Level 3 - +7 Strength, +2 armor.

Mark of the Sapper Continual. You don't have any idea how it is being a sapper, doomed to explode... Now you do. Give a buff to an enemy unit, and if the unit is attacked during the effect of the spell, it triggers an explosion dealing extra damage to the unit, and the effect ends. Mana cost 30, cooldown 2.5.
Level 1 - Mark lasts 4 seconds, explosion deals 40 damage to target.
Level 2 - Mark lasts 8 seconds, explosion deals 70 damage to target.
Level 3 - Mark is permanent until attacked, explosion deals 100 damage to target.

Engineering - This skill is passive and its levels works as requirements and upgrades for the building the Tinker can construct. Thing is, the tinker has that construct building icon as any peon has. The buildings are in fact quite as normal summonings, but he builds them like a peon would and then there is an expiration timer added by a trigger as soon as the construction is complete. A building takes 12 seconds to construct and lasts for 35 seconds.
Level 1 - Enables the Tinker to construct Power Node.
Level 2 - Enables the Tinker to construct Factory and increases mana capicity of the Power Node.
Level 3 - Increases the explosion damage of the Clockwerk goblins from the Factory and enables the Power Node to cast Chainlightning.

THE BUILDINGS
Power Node
This is a construction of energy and electricity. As a model use either Energy Tower (with another or none ground texture) or some very small-scale orc building with a lightning bolt constantly smashing down into it. The Power Node has 350 hit points and 200 mana (300 when Engineering reaches lvl 2) and a lesser mana regeneration. The Power Node has 3 spells;
Stasis Trap - Yep. Its the same as the Witch Doctor skill.
Transfer Energy - This works like Siphon Mana (Blood Mage) but can ONLY be used to transfer mana to an ally, not to steal it from an enemy.
Chainlightning - Enabled when Engineering reaches lvl 3. Deals 120 damage, up to 5 targets (15% dmg reduction per target), mana cost 75 and cooldown 9.

Factory
This is the very same as the Factory summoned by the original Pocket Factory skill, but has 400 hit points. The Clockwerk Goblins deal 50 damage upon sapping, 75 damage when Engineering has reached lvl 3.

Repair - Ulti. Could seem lame to have repair as an ultimate, but not only can the Tinker repair his buildings and ally machines, but he can also repair HIMSELF while in Robo-Goblin form! Neither Robo-Goblin or any of the buildings cost resources to repair, so balancing repair time is essential.


NOTE: I think you can easily make the systems for the requirements and upgrades for buildings constructed by the Tinker and linking them to the Engineering skill. Use a lot of Upgrades in the object editor and then make triggers enabling (and disabling) different things. Tell me if I should help you with this or if there is something you don't understand. At least I gave you an idea :p
 
General chit-chat
Help Users
  • No one is chatting at the moment.
  • Monovertex Monovertex:
    How are you all? :D
    +1
  • Ghan Ghan:
    Howdy
  • Ghan Ghan:
    Still lurking
    +3
  • The Helper The Helper:
    I am great and it is fantastic to see you my friend!
    +1
  • The Helper The Helper:
    If you are new to the site please check out the Recipe and Food Forum https://www.thehelper.net/forums/recipes-and-food.220/
  • Monovertex Monovertex:
    How come you're so into recipes lately? Never saw this much interest in this topic in the old days of TH.net
  • Monovertex Monovertex:
    Hmm, how do I change my signature?
  • tom_mai78101 tom_mai78101:
    Signatures can be edit in your account profile. As for the old stuffs, I'm thinking it's because Blizzard is now under Microsoft, and because of Microsoft Xbox going the way it is, it's dreadful.
  • The Helper The Helper:
    I am not big on the recipes I am just promoting them - I use the site as a practice place promoting stuff
    +2
  • Monovertex Monovertex:
    @tom_mai78101 I must be blind. If I go on my profile I don't see any area to edit the signature; If I go to account details (settings) I don't see any signature area either.
  • The Helper The Helper:
    You can get there if you click the bell icon (alerts) and choose preferences from the bottom, signature will be in the menu on the left there https://www.thehelper.net/account/preferences
  • The Helper The Helper:
    I think I need to split the Sci/Tech news forum into 2 one for Science and one for Tech but I am hating all the moving of posts I would have to do
  • The Helper The Helper:
    What is up Old Mountain Shadow?
  • The Helper The Helper:
    Happy Thursday!
    +1
  • Varine Varine:
    Crazy how much 3d printing has come in the last few years. Sad that it's not as easily modifiable though
  • Varine Varine:
    I bought an Ender 3 during the pandemic and tinkered with it all the time. Just bought a Sovol, not as easy. I'm trying to make it use a different nozzle because I have a fuck ton of Volcanos, and they use what is basically a modified volcano that is just a smidge longer, and almost every part on this thing needs to be redone to make it work
  • Varine Varine:
    Luckily I have a 3d printer for that, I guess. But it's ridiculous. The regular volcanos are 21mm, these Sovol versions are about 23.5mm
  • Varine Varine:
    So, 2.5mm longer. But the thing that measures the bed is about 1.5mm above the nozzle, so if I swap it with a volcano then I'm 1mm behind it. So cool, new bracket to swap that, but THEN the fan shroud to direct air at the part is ALSO going to be .5mm to low, and so I need to redo that, but by doing that it is a little bit off where it should be blowing and it's throwing it at the heating block instead of the part, and fuck man
  • Varine Varine:
    I didn't realize they designed this entire thing to NOT be modded. I would have just got a fucking Bambu if I knew that, the whole point was I could fuck with this. And no one else makes shit for Sovol so I have to go through them, and they have... interesting pricing models. So I have a new extruder altogether that I'm taking apart and going to just design a whole new one to use my nozzles. Dumb design.
  • Varine Varine:
    Can't just buy a new heatblock, you need to get a whole hotend - so block, heater cartridge, thermistor, heatbreak, and nozzle. And they put this fucking paste in there so I can't take the thermistor or cartridge out with any ease, that's 30 dollars. Or you can get the whole extrudor with the direct driver AND that heatblock for like 50, but you still can't get any of it to come apart
  • Varine Varine:
    Partsbuilt has individual parts I found but they're expensive. I think I can get bits swapped around and make this work with generic shit though

      The Helper Discord

      Members online

      Affiliates

      Hive Workshop NUON Dome World Editor Tutorials

      Network Sponsors

      Apex Steel Pipe - Buys and sells Steel Pipe.
      Top