They only CLAIM they cant load, Did you test ingame? To get them to appear in the Map editor you have to save, get out of the editor, then get back in.
1.
If you import a model and place it on the Editor, its a purple/green box. And below says "DemonHunter.mdx" cannot load..
You need save the map, exit the Editor and Go back right in.
2. If you import a model with blp. model. Still the same. =))
3. Make sure the paths of blp. are correct.
If you downloaded the model from The Hive, the BLP paths you need are listed on the page you downloaded the model from. If you downloaded the model from another site, or got it from a friend, there should still be information on any paths you might need.
I am having the same problem. I know the .blp path is correct, because the model is used on another mep I have & it works fine (someone else's map). It kept telling me it couldn't load .mdl file (even though I had the .mdx and .blp set, the model property kept reverting to .mdl from .mdx in the editor). So I converted the original .mdx into .mdl and imported the .mdl into the map. Now it works and shows up just fine in the editor, but doesn't show up at all in the game. :banghead:
Signatures can be edit in your account profile. As for the old stuffs, I'm thinking it's because Blizzard is now under Microsoft, and because of Microsoft Xbox going the way it is, it's dreadful.
@tom_mai78101 I must be blind. If I go on my profile I don't see any area to edit the signature; If I go to account details (settings) I don't see any signature area either.
You can get there if you click the bell icon (alerts) and choose preferences from the bottom, signature will be in the menu on the left there https://www.thehelper.net/account/preferences
I bought an Ender 3 during the pandemic and tinkered with it all the time. Just bought a Sovol, not as easy. I'm trying to make it use a different nozzle because I have a fuck ton of Volcanos, and they use what is basically a modified volcano that is just a smidge longer, and almost every part on this thing needs to be redone to make it work
So, 2.5mm longer. But the thing that measures the bed is about 1.5mm above the nozzle, so if I swap it with a volcano then I'm 1mm behind it. So cool, new bracket to swap that, but THEN the fan shroud to direct air at the part is ALSO going to be .5mm to low, and so I need to redo that, but by doing that it is a little bit off where it should be blowing and it's throwing it at the heating block instead of the part, and fuck man
I didn't realize they designed this entire thing to NOT be modded. I would have just got a fucking Bambu if I knew that, the whole point was I could fuck with this. And no one else makes shit for Sovol so I have to go through them, and they have... interesting pricing models. So I have a new extruder altogether that I'm taking apart and going to just design a whole new one to use my nozzles. Dumb design.
Can't just buy a new heatblock, you need to get a whole hotend - so block, heater cartridge, thermistor, heatbreak, and nozzle. And they put this fucking paste in there so I can't take the thermistor or cartridge out with any ease, that's 30 dollars. Or you can get the whole extrudor with the direct driver AND that heatblock for like 50, but you still can't get any of it to come apart