Is it possible to reduce a units movement speed to zero? Or otherwise, is there a reliable way to make units unable to move and able to move without using pause units.
No you can't set a unit's movement speed to 0. Neither with triggers nor by shift clicking the value, it will still refer to the lowest possible value. The best way to make units unable to move would be to use ensnare, but you can't really remove it that easily.
What you can do is run a timer and set the units coordinates to the point they were at from the beginning, it won't interrupt attacks or abilities like "Unit - Move unit" does.
Faust is right. set the minimum movement speed to 0 in the gameplay constants and set the movement speed of your unit to 0 in a trigger as well. this makes your unit unable to move but it will still have its "patrol" "stop" "move" and "hold position" buttons. to remove the icons as well you got to remove the ability "move" from the unit.
move cannot be added anymore.
Hm yes, when you change the value in gameplay constants your able to set it to 0 but then hold, patrol and move disappears from the UI. Just tested it.
Signatures can be edit in your account profile. As for the old stuffs, I'm thinking it's because Blizzard is now under Microsoft, and because of Microsoft Xbox going the way it is, it's dreadful.
@tom_mai78101 I must be blind. If I go on my profile I don't see any area to edit the signature; If I go to account details (settings) I don't see any signature area either.
You can get there if you click the bell icon (alerts) and choose preferences from the bottom, signature will be in the menu on the left there https://www.thehelper.net/account/preferences
I bought an Ender 3 during the pandemic and tinkered with it all the time. Just bought a Sovol, not as easy. I'm trying to make it use a different nozzle because I have a fuck ton of Volcanos, and they use what is basically a modified volcano that is just a smidge longer, and almost every part on this thing needs to be redone to make it work
So, 2.5mm longer. But the thing that measures the bed is about 1.5mm above the nozzle, so if I swap it with a volcano then I'm 1mm behind it. So cool, new bracket to swap that, but THEN the fan shroud to direct air at the part is ALSO going to be .5mm to low, and so I need to redo that, but by doing that it is a little bit off where it should be blowing and it's throwing it at the heating block instead of the part, and fuck man
I didn't realize they designed this entire thing to NOT be modded. I would have just got a fucking Bambu if I knew that, the whole point was I could fuck with this. And no one else makes shit for Sovol so I have to go through them, and they have... interesting pricing models. So I have a new extruder altogether that I'm taking apart and going to just design a whole new one to use my nozzles. Dumb design.
Can't just buy a new heatblock, you need to get a whole hotend - so block, heater cartridge, thermistor, heatbreak, and nozzle. And they put this fucking paste in there so I can't take the thermistor or cartridge out with any ease, that's 30 dollars. Or you can get the whole extrudor with the direct driver AND that heatblock for like 50, but you still can't get any of it to come apart